UTVBlog - Your Source for UTV and Side By Side News!

Racer Tech Polaris RZR 2″ LIFT KIT


racertechrzr2lift“Introducing the new Racer Tech 2” RZR Lift Kit. It was brought to our attention that almost EVERY lift kit on the market has been causing serious CV and boot damage in short time. This is just ridiculous… A company should have tested proven and functional products. Not slapped together junk. Here at Racer Tech we do things right the first time, period. With that said, we are proud to present the first lift kit that WILL NOT cause any CV issues for the remainder of the life of your RZR. We know this because we’ve tested the kit and can honestly say the rear will not droop any lower than the factory setup. We achieve this by relocating the UPPER shock mounts and not the lowers. This method improves the shock angles which require a lower spring rate to hold the vehicle at ride height. When retaining the stock springs however, the ride height is raised. This kit will allow you to back the “clickers” on your shocks down and still have the desired height needed for that additional ground clearance. So you get two things with this kit. A taller ride height PLUS an improved ride! Actual height gains will vary but expect approximately 1.5” rear lift and 2” front. We’ve found our best performance with these machines by setting the fronts 0.5-1” taller. Another improvement we make with this kit is correcting the front sway bar travel. This may not be extremely noticeable to most, but it’s just another way Racer Tech takes care of business! This kit is all bolt-on and the installation can be completed in less than 1.5 hours. There are four holes to be drilled in the rear of the frame for the ultimate in strength but this job is made simple by very thorough instructions. Kit comes complete with all necessary components, hardware and instructions for complete installation. Kits are powdercoated your choice of Black, RZR Red or LE Silver. WE ALSO OFFER: Replacement spring kits for fine tuning your ride once you’ve achieved you desired height. ALSO AVAILABLE: Quick Disconnect front sway bar kit – This can be an upgrade to your existing kit! Coming soon: Spring Shims – These handy pieces will bump up your preload if you need just a little more height or firmness. They’re stackable too. For more info see www.goracertech.com

Similar posts plugin not found.
UTV Forums Network UTVBlog.net Sponsors
Latest Comments Latest Previews Latest Reviews The UTVBlog Archives
Tags